Skip to content
  • There are no suggestions because the search field is empty.

Checklist

Complete this setup checklist before continuing the mobile app

1. Make sure the sensor has power (green LED on the 12V connector and LED light around RESTART button is on). If that is not the case, check that all connections are properly plugged in and the vehicle has power.

2. The GPS antenna is mounted pointing up towards the sky and connected

3. You are located at the facility where the mowers will return to and be stored, but outside with a clear view of the sky.

4. You have access to WiFi and you have the password ready.

5. You have enabled Bluetooth on your phone or tablet.

6. Confirm that the blue LED light around the FUNCTION button is blinking slowly, this confirms that a GPS satellite signal has been acquired. (Note that this can take several minutes!) If the sensor is beeping continuously and you don’t see the blue FUNCTION LED, the internal battery is discharged and the sensor needs to be connected to a power source and charged for approx. 1 hour.

Now you are ready to configure your turfRad sensor!